JVC AV32X25EU, AV28X25EU, AV28H20EU, AV32H20EU manual EXT Setting, „ Bbe, „ Hyper Sound, „ Speaker

Using the TV’s menu

„BBE

You can use the BBE function to enjoy easy- to-listen sound that is faithful to the original sound recorded.

ON:

This function is turned on.

OFF:

This function is turned off.

Licensed by BBE Sound, Inc. BBE is a registered trademark of BBE Sound, Inc.

„HYPER SOUND

You can enjoy sounds with a wider ambience.

ON:

This function is turned on.

OFF:

This function is turned off. The menu disappears.

•The HYPER SOUND function does not work properly with mono sound.

•You can turn on or off the HYPER SOUND function with a single press. For details, see “HYPER SOUND function” on page 12.

„SPEAKER

(Excluding AV28CH1EU)

You can turn off the sound from the TV speakers; but you should only do this if an audio system is connected to the TV as a substitute for the TV speakers.

ON:

The TV speakers issue sound.

OFF:

The TV speakers does not issue sound.

•The 5buttons of the TV remote control and the r(volume) buttons at the front panel of your TV set can be used to control the volume of each speaker simultaneously.

•Setting the volume of the amplifier too high may damage the front speakers.

	EXTSETTING1
EXT SETTING			DUBBING
		3
	EXT-4		EXT-2
TV	TVBACK		IDLIST
		OK	S-IN
D0020-EN

„S-IN (S-VIDEO input)

When connecting a device (such as S-VHS VCR) which enables an S-VIDEO signal (Y/ C signal) to be output, you can enjoy high- quality picture of the S-VIDEO signal (Y/C signal).

Preparation:

•At first, read the Device Instruction Manual and “Additional preparation” on page 36 to connect the device to the TV properly. Second, follow the Device Instruction Manual to set the device so that an S-VIDEO signal (Y/C signal) can be output to the TV.

•Do not set S-IN (S-VIDEO input) to the EXT terminal connected to a device which cannot output an S-VIDEO (Y/C signal). If it is set wrongly, a picture cannot appear.

1Choose an EXT terminal

2Press the yellow button and set the S-IN (S-VIDEO input).

Then press the abutton

An S-IN (S-VIDEO input) mark is displayed. You can view an S-VIDEO signal (Y/C signal) instead of the regular video signal (composite signal).

22