Switching input signal
The projector can be connected to multiple devices at the same time. However, it can only display one full screen at a time. To cycle through the available input sources, press SOURCE on the projector or remote control. The selected source name will display in the lower right corner of the screen for 3 seconds after each button press.
The projector features PIP function which allows 2 different signals to be displayed at the same time. See "PIP (Picture In Picture) operation" on page 39 for details.
The brightness level of the projected image will change accordingly when you switch between
different input signals. Data (graphic) "PC" presentations using mostly static images are generally brighter than "Video" using mostly moving images (movies). When switching between different signal inputs, you will need to adjust the ambient lighting conditions for the best picture quality.
The input type affects the options available for the Preset Mode. See "Selecting a preset mode" on page 35 for details.
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 2
1.Press the
front of the projector. Once the image is positioned where you want it, release the
Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyes.
Be careful when you press the adjuster buttons as
they are close to the exhaust vent where hot air comes from.
2.Screw the rear adjuster feet to fine tune the
horizontal angle.
To retract the foot, hold up the projector while pressing the
If the screen and the projector are not perpendicular to each other, the projected image becomes vertically trapezoidal. To correct this situation, adjust the value of Keystone in the
Display menu, on the projector control panel, or on the remote control. See "Correcting keystone" on page 34 for details.
Operation 31
