A warning message like the one pictured to the right will be displayed for 10 seconds every 300 hours of use to remind you to clean the filters.
IMPORTANT: Please ensure that the projector is properly shutdown before removing the filters for cleaning or replacement.
Please check if the filter is clean. Please clean the filter by using a small vacuum or brush if the filter is dirty.
Press Exit to confirm.
This projector has two concealed filters. One is fitted behind the front vent grill (see item 7 on page 11), and the other is on the left side (see item 16 on page 11).
Front filter
1A. Access to the front dust filter is located on the right side of the projector towards the front edge. Use your thumb or finger to pull it out from the side as illustrated in diagram 'A' below.
1B. If the front filter proves difficult to remove, you should use a broad flat implement (like an
1C. Carefully pull the filter cartridge out from the side of the projector while keeping it parallel with the front as illustrated in diagram 'C' below
A. | B. | C. |
Rear filter
2.Access to the rear dust filter is located on the left side
of the projector towards the rear. Use your thumb or finger to pull it out from the side as illustrated below.
3. To clean the filters, use a small vacuum cleaner designed for computers and other office equipment, or use a soft brush (such as a clean artist's paintbrush) to gently sweep the dust away. Refit and align the filter sponge to sit snugly within the filter
frame for the front filter, so that no obvious gaps are visible around the edges between the edge of the filter sponge and the plastic filter frame housing. If the dirt is difficult to remove or the filters are
broken, replace them. Contact your dealer or visit BenQ website at www.BenQ.com for more service information.
4.Carefully refit the filters to the projector then press the covers back until they click into place.
Maintenance 49
