Operation / Cleaning, maintenance and disposal
jTo safeguard your fingers always use the food carriage 10 and the food holder plate 11 (Ex- ception: slicing very large pieces of foodstuffs).
QCleaning, maintenance and disposal
QCleaning
Important safety advice for cleaning the slicer
1.Before starting to clean the slicer; switch it off, remove the plug from the mains socket and set the food support plate 13 into the „0“ setting.
2.Do not submerse the slicer in water.
3.m Attention! Risk of serious injury: The cutting blade 12 is very sharp!
Accessories suitable for dishwashers!
jClean the food carriage 10, the food holder 11 and the
jIt is necessary to clean the slicer thoroughly at regular intervals as perishable food scraps could accumulate on the appliance or behind the cutting blade 12.
jClean all appliance parts not suitable for the dishwasher with a lightly moistened cloth. Wipe off the appliance housing 5 , the cutting blade covering 6 , the support table with guide slots 9 and the food support plate 13 carefully. Do not use abrasive cleaning agents, sponges with rough surfaces or hard brushes.
Cleaning brush:
jUse the bristles of the cleaning brush 19 to re- move remnants such as crumbs from all difficult to reach positions. The flattened end can be excellently used to remove stubborn soiling.
jCarry out all tasks using the cleaning brush with great care. Should it slip close to the cutting blade, there is the risk of receiving a severe personal injury.
10 GB
QMaintenance / Removing / assembling the cutting blade
Important safety notices for the removal and assembly of the cutting blade!
1.Switch the slicer off, remove the plug from the power socket and set the food support plate 13 into position „0“.
2.m Attention! Risk of personal injury! The cutting blade is very sharp! For the removal and assembly wear appropriate safety gloves. Otherwise, you could receive cut injuries.
jOpen the blade cover 6 by pressing the blade cover unlock button 4 . Remove the blade cover 6 .
jRemove the plastic screw clip 18 from the mounting and screw the blade lock of the cut- ting blade 12 out by unscrewing it to the left.
jWhen taking out the blade 12 make sure that you grasp it at its centre.
jThe cutting blade 12 can be cleaned in the dishwasher.
jClean the housing behind the blade with a dry cloth or a soft brush.
j
jDue to the special sawtoothing and the high quality, the cutting blade will retain its sharp- ness for a very long time. A resharpening of the cutting blade is not necessary. Consult the service centre for your country if you have questions about the cutting blade.
QSpecial accessories
Round cutter:
An untoothed cutting blade, specifically for the finest of slices, is also available.
Orders for special accessories are be directed to the service centre for your country.
