Billion Electric Company user manual Configuring Password, Resetting the Bipac 5100S

2.4 Configuring Password

It is highly recommended that you change the password for accessing the BIPAC 5100S. To change the BIPAC 5100S’s password, click Advanced Setup and then Password. The screen appears as shown.

The following table describes the labels in this screen.

LABEL	DESCRIPTION
Old Password	Type the default password or the existing password you use to access the
	system in this field.
New Password	Type the new password in this field.
Retype to Confirm	Type the new password again in this field.
Apply	Click Apply to save your changes back to the BIPAC 5100S.
Cancel	Click Cancel to begin configuring this screen afresh.

2.5 Resetting the BIPAC 5100S

If you forget your password or cannot access the BIPAC 5100S, you will need to reload the factory-default configuration file or use the RESET button the back of the BIPAC 5100S. Uploading this configuration file replaces the current configuration file with the factory-default configuration file. This means that you will lose all configurations that you had previously and the password will be reset to “admin”.

2.5.1 Using The Reset Button

Step 1. Make sure the SYS LED is on (not blinking).

Step 2. Press the RESET button for five seconds, and then release it. When the SYS LED begins to blink, the defaults have been restored and the BIPAC 5100S restarts.

11