ServSwitch Wizard VGA (USB)
3.2.2 Computer systems
Each computer system is connected to the ServSwitch Wizard VGA (USB) unit using up to three cables for the KV3004A and up to six cables for the KV3204A, KV3304A and KV3404A.
To connect a computer system
1Ensure that power is disconnected from the ServSwitch Wizard VGA (USB) unit and the system to be connected.
2Use a USB cable
2 1
| USB1 |
USB2.0 |
|
SWITCHED | USB2 |
Figure
3If required, use a stereo audio link cable
4Single screen units: Link the video output of the computer’s graphic port to the VGA port of the required channel on the rear of the unit. See Figure
2 1
| USB1 |
USB2.0 |
|
SWITCHED | USB2 |
Figure
During initial power up, the Wizard unit will attempt to read the EDID information from the connected display(s). See Section 3.2.6 for details.
Page 16 |