ServSwitch Wizard VGA (USB)
|
| Table |
Letter | Number | Description |
B |
| Enter the OPTIONS port Baud rate menu |
| 1 | 1200 (default) |
| 2 | 2400 |
| 3 | 9600 |
| 4 | 19200 |
| 5 | 38400 |
| 6 | 57600 |
| 7 | 115200 |
F |
| Enter the Functions menu |
| 1 | Show current firmware version |
| 2 | Refresh EDID information from the connected video display (default) |
| 3 | Use the stored EDID at startup, do not interrogate the video display |
| 8 | Reset configuration to factory defaults ( is displayed momentarily) |
H |
| Enter the Hotkey menu |
| 1 | Ctrl + Alt (default) |
| 2 | Ctrl + Shift |
| 3 | Alt + Shift |
| 4 | Right Alt |
| 5 | Alt |
| 6 | Left Ctrl + Alt |
| 7 | Right Ctrl + Alt |
| 8 | Hotkeys disabled |
O |
| Enter the Options port behavior menu |
1Channel switching via
2Channel switching via remote. Contact switching disabled (reserved for future use).
3As per 1 but with contact switching enabled.
P | Set a new password for use with the lock mode |
S | Enter the Switch Mode menu |
1All (default)
2KVM + Speaker
3KVM only
4Speaker only
5USB1 only
6USB2 only
T | Enter the Autoscan Time Delay menu |
1Autoscan disabled
22 seconds
35 seconds (default)
47 seconds
515 seconds
630 seconds
71 minute
85 minutes
U | Enter the User Preferences menu |
1 | Enable mouse switching (default) |
2 | Disable mouse switching |
7 | Cycle all ports (when using ‘Hotkey + Tab’ or ‘Autoscan’) (default) |
8 | Cycle only active ports (when using ‘Hotkey + Tab’ or ‘Autoscan’) |
Page 24 |