Black Box Black Box ServSwitch Wizard VGA (USB) where xxx is the firmware version, Configuration

Chapter 4: Configuration

7From the main KVM Firmware Uploader dialog, click the Browse... button and select the upgrade file: VGAUSB_xxx.txt

where xxx is the firmware version.

The upgrade file details will be displayed within the dialog.

IMPORTANT: Check that the ‘Intended Target Units’ field matches the ‘Unit Connected’ field. If these fields do not match then you may have an incorrect upgrade file, check with Black Box Technical Support before proceeding. Check also that the ‘New firmware version’ is greater than the ‘Current firmware version’. See Figure 4-2.

Check that the ‘Intended Target Units’ field matches the ‘Unit Connected’ field.

Check also that the ‘New firmware version’ is greater than the ‘Current firmware version’.

Figure 4-2.KVM Firmware Uploader utility screen with upgrade file selected.

8To begin the upgrade process, click the Upload Now button. The progress will be shown within the dialog. Should you decide not to continue with the upload at any stage, click the Abort button; response to this is usually immediate, however, during an erase command, the upload will not be aborted until the erase is complete (this may take a few seconds).

9Disconnect the power. When the power is re-applied the ServSwitch Wizard VGA (USB) unit will operate using the new firmware.

Issues to consider when performing flash upgrades

The upgrade program rewrites the internal firmware code. If the upgrade process is interrupted then the unit will have invalid code and will not be able to operate. It is therefore good practice to ensure that the upgrade process is always fully completed. A partial or failed upgrade may be rectified by performing another upgrade.

WARNING: Running faulty or partially upgraded code may have unpredictable results and may damage your ServSwitch Wizard VGA (USB) unit or computing equipment.

724-746-5500 blackbox.com Page 29