ServSwitch™ Wizard DP USB
4. Configuration
4.1 Using the configuration menu
The configuration mode allows you to determine numerous aspects of the Wizard DP USB unit capabilities.
4.1.1 Using the configuration menu
During normal use, the seven segment display on the front panel shows the number of the currently selected computer channel. From this condition, enter configuration mode as follows:
1Press and hold the front panel COMPUTER button for roughly five seconds.
The display will show:
2On the keyboard, press the letter key for the required menu section, e.g.
The display will show the pressed letter, e.g.
3Press the number of the required setting, e.g. The display will show the pressed number, e.g.
4Press to accept the setting and return to the main menu section.
The display will show:
5You can now continue with your next configuration change (go to step 2), or exit from the configuration menu (see below).
To exit the configuration menu and save changes
•Press and then press to exit and save changes. To exit the configuration menu without saving
•Press either of the front panel buttons.
Enter the OPTIONS port Baud rate menu
1200 (default) | 38400 |
2400 | 57600 |
9600 | 115200 |
19200 |
|
Enter the Functions menu
Show current firmware version
Reset configuration to factory defaults ( is displayed momentarily)
Enter the Hotkey menu |
|
Ctrl + Alt (default) | Alt |
Ctrl + Shift | Left Ctrl + Alt |
Alt + Shift | Right Ctrl + Alt |
Right Alt | Hotkeys disabled |
Enter the Options port behavior menu
Channel switching via
Channel switching via RC4 remote. Contact switching disabled.
As per but with contact switching enabled. Set a new password for use with the lock mode Enter the Switch Mode menu
All (default)
KVM + Speaker
KVM only
Speaker only
USB1 only
USB2 only
Enter the Autoscan Time Delay menu
Autoscan disabled | 15 seconds |
2 seconds | 30 seconds |
5 seconds (default) | 1 minute |
7 seconds | 5 minutes |
Enter the User Preferences menu
Enable mouse switching (default) Disable mouse switching
Cycle all ports (when using ‘Hotkey + Tab’ or ‘Autoscan’) (default)
Cycle only active ports (when using ‘Hotkey + Tab’ or ‘Autoscan’)
You can press |
|
at any point to exit | (default) or (d) denote |
from an option and | the default settings |
return to the main | for each group of |
menu ( ) section. | options. |
Page 18 |