ServSwitch™ Wizard DP USB
4.2.4 OPTIONS port channel control behavior
You can determine how the OPTIONS port responds to channel control inputs.
4.2.4.1 To define the OPTIONS port behavior
1Enter the Configuration menu.
2Press 
to enter the Options port menu and then press either:
to allow channel switching commands to be received via 
option will be used for the port. Switching commands via the four channel select inputs within the OPTIONS port connector are disabled in this mode. Use option 
if you wish to enable the channel select inputs in addition to
to allow channel switching commands to be received from the optional remote control. The baud rate set by the 
option is ignored and the rate used by the remote control is automatically imposed. Switching commands via the four channel select inputs within the OPTIONS port connector are disabled in this mode.
enables channel switching via 
. However, in this mode the four channel select inputs are also enabled.
3Press 
to accept the setting and return to the main menu section.
4Press 
and then 
to exit the menu and save changes.
4.2.5 Switching mode
Using the configuration menu, you can define a default switching mode. The switching mode determines which peripherals (KVM, USB1, USB2 and/or speakers) should be moved to the next computer when it is selected using any of the standard meth- ods. Regardless of the default switching mode set here, during use you can always change the mode using either the MODE but- ton (on the front panel) or using the additional hotkey press combinations.
Note: Of the external switching methods, the optional remote control and the
4.2.5.1 To set the default switching mode
1Enter the Configuration menu.
2Press 
to enter the Switch Mode menu and then press either:
to select All (default)
to select KVM and speaker
to select KVM only
to select Speaker only
to select USB1 only
to select USB2 only
3Press 
to accept the setting and return to the main menu section.
4Press 
and then 
to exit the menu and save changes.
Page 20 |
