Hand Held Products 4620, 2020 Standard Product Default Settings Current Application Group

Resetting the Standard Product Default Settings: All Application Work Groups

The following bar code defaults all of the work groups to the factory settings.

Standard Product Default Settings:

All Application Groups

The Menu Commands starting on page 12-6list the standard product default settings for each of the commands (indicated by an asterisk (*) on the programming pages).

Resetting the Standard Product Default Settings: Current Application Work Group

If you aren’t sure what programming options are in your imager, or you’ve changed some options and want the standard product default settings restored, scan the Standard Product Default Settings: Current Application Group bar code below.

The Menu Commands starting on page 12-6 list the factory default settings for each of the commands (indicated by an asterisk (*) on the programming pages).

Note: Scanning this bar code also causes both the imager and the base to perform a reset and become unlinked. Refer to "Imager Modes" on page 3-5 for additional information.

Standard Product Default Settings:

Current Application Group

Note: If your imager is in multiple imager mode and you scan either the current or all application group default bar code, you will hear up to 30 seconds of beeping while all imagers are re-linked from the base and the settings are defaulted to * settings. The default interface is keyboard wedge and the default imager mode is single imager locked link mode.

3 - 10 IMAGETEAM™ 2020/4620 System Manual