Hand Held Products 2020, 4620 Imager Modes, Single Imager Operation, Unlinking the Imager

Imager Modes

The IT4620 is capable of working in single imager mode, multiple imager mode, or with Blutetooth devices, other than the IT2020-5B base.

Unlinking the Imager

If the base has an imager linked to it, that imager must be unlinked before a new imager can be linked. Once the previous imager is unlinked, it will no longer communicate with the base. To unlink an imager from the base, scan the Unlink Imager bar code below.

Unlink Imager

Single Imager Operation

There are two link modes to accommodate different applications: Locked Link Mode and Open Link Mode. Scan the appropriate bar codes included in the Open Link and Locked Link Mode explanations that follow to switch from one mode to another. Default = Locked Link Mode.

Locked Link Mode - Single Imager

If you link an imager to a base using the Locked Link Mode, other imagers are blocked from being linked if they are inadvertently placed into the base. If you do place a different imager into the base, it will charge the imager, but the imager will not be linked.

*Locked Link Mode (Single Imager)

To use a different imager, you need to unlink the original imager by scanning the Unlink Imager bar code. (See "Imager Modes" on page 3-5.)

IMAGETEAM™ 2020/4620 System Manual 3 - 5