Hand Held Products 2020, 4620 system manual Imager Power Time-Out Timer

Imager Power Time-Out Timer

Note: The Imager Power Time-out Timer option only applies to Manual/Serial Trigger.

When there is no activity within a specified time period, the imager enters low power mode. Scan the appropriate Imager Power Time-Out bar code to change the time-out duration (in seconds).

Note: Scanning zero (0) is the equivalent of setting no time-out.

If there are no trigger pulls during the “imager power time-out timer” interval, the imager goes into power down mode. Whenever the trigger is enabled, the “imager power time-out timer” is reset. If the imager is placed in the IT2020-5B cradle and the battery is in the process of being charged, the imager will not go into power down mode.

0 seconds

200 seconds

400 seconds

900 seconds

* 3600 seconds

7200 seconds

Note: When the imager is in power down mode, pull the trigger to power the unit back up. There will be a set of power up beeps and a delay of up to a few seconds for the radio to join. The imager will then be ready to use.

IMAGETEAM™ 2020/4620 System Manual 4 - 5