Hand Held Products 4620, 2020 system manual Multiple Imager Operation, Open Link Mode Single Imager

Open Link Mode - Single Imager

When newly shipped or defaulted to factory settings, the base and imager are not linked. By placing an imager into the base, they establish a link. Placing a different imager into the base establishes a new link and the old imager is unlinked. Each time an imager is placed into the base, it becomes the linked imager; the old imager is unlinked.

Open Link Mode

(Single Imager)

Override Locked Imager

If you need to replace a broken or lost imager that is linked to a base, scan the Override Locked Imager bar code below with a new imager and place that imager in the base. The locked link will be overridden; the broken or lost imager’s link with the base will be removed, and the new imager will be linked.

Override Locked Imager

(Single Imager)

Multiple Imager Operation

To put the imager in multiple imager mode, scan the bar code below. Once you scan this bar code, the imager is unlinked from the base and must be placed into the base to re-link.

Multiple Imager Operation

Note: Multiple Imager Operation Mode allows you to link up to 7 imagers to one base. You cannot join an eighth imager until you unlink one of the 7 imagers or take an imager out of range.

3 - 6 IMAGETEAM™ 2020/4620 System Manual