Hand Held Products 4620, 2020 system manual Linking Imager to Base

Linking Imager to Base

When newly shipped or defaulted to factory settings, the base and imager are not linked. Once the imager is placed into the base, the software automatically links the imager and the base. If the imager and base have previously been linked, you do not receive any feedback. If this is the first time that the imager and base are linked, both devices emit a short chirp when their radios link. At this point, you are set to one imager to one base.

IT4620 Imager

Green LED
Red LED	IT2020-5B Cordless Base

1.Provide power to the base.

2.Place the IT4620 into the base. The imager and base link.

3.To determine if your cordless system is set up correctly, scan one of the sample bar codes in the back of this manual. If the imager provides a single good read beep and the green LED lights, the imager has successfully linked to the base. If you receive a triple error beep and the red LED lights, the imager has not linked to the base.

1 - 8 IMAGETEAM™ 2020/4620 System Manual