Hand Held Products 4620, 2020 system manual Imager Address, Base Address

Imager Report

Scan the bar code below to generate a report for the connected imagers. The report indicates the port, work group, imager name, and address. To assign a name to your imager, refer to "Menu Command Syntax" on page 12-1.

Imager Report

Imager Address

Scan the bar code below to determine the address of the imager you are using.

Imager Address

Base Address

Scan the bar code below to determine the address of the base you are using.

Base Address

Resetting the Standard Product Default Settings: Current Application Work Group

If you aren’t sure what programming options are in your imager, or you’ve changed some options and want the standard product default settings restored, scan the Standard Product Default Settings: Current Application Group bar code below.

The Menu Commands starting on page 12-6list the factory default settings for each of the commands (indicated by an asterisk (*) on the programming pages).

Note: Scanning this bar code also causes both the imager and the base to perform a reset and become unlinked. Refer to "Imager Modes" on page 3-5 for additional information.

Standard Product Default Settings:

Current Application Group

11 - 2 IMAGETEAM™ 2020/4620 System Manual