Hand Held Products 2020, 4620 system manual Imager Name

Imager Name

You are able to assign a name to each imager you are using. It will be helpful to name the imagers if you have multiple imagers linked to one base so that you will be able to control the imager receiving imaging commands sent from the base.

The default name for an IT4620 is “IT4620”. If you have more than one IT4620 linked to a base, the first imager that is linked to the base receives commands addressed using this name. If you wish to change the name, you may change it via a serial command (refer to "Menu Command Syntax" on page 12-1) or via a bar code command. To change the name serially, unlink all except one of the IT4620s from the base. Send “:IT4620:BT_NAMname.”, where name is the new imager name. If you wish to change the name of additional IT4620s, re-link them one at a time and repeat the “:IT4620:BT_NAMname.” command for each imager.

If you wanted set up your imagers with names 0001-0007, you may scan the bar codes below. Scan the Reset bar code after each name change and wait for the scanner to re-link to the base before scanning the next bar code to name the next imager.

0001

0002

0003

0004

0005

0006

0007

Reset

IMAGETEAM™ 2020/4620 System Manual 3 - 7