Hand Held Products 2020, 4620 system manual LED Power Level, Illumination Lights

LED Power Level

This selection allows you to adjust LED and aimer brightness. Off is used when no illumination is needed. Low is used if low illumination is sufficient. High (the default) is the brightest setting.

If you have an aimer delay programmed (see Aimer Delay on page 4-10), the aimer will be at 100% power during the delay, regardless of the LED Power Level.

Note: If you scan the Off bar code, both the aimer and illumination lights turn off, making it impossible to scan bar codes in low light. To turn the LED Power Level back on, move to a brightly lit area and scan either the Low or the High bar code below.

Off

Low (50%)

*High (100%)

Illumination Lights

If you want the illumination lights on while reading a bar code, scan the Lights On bar code, below. However, if you want to turn just the lights off, scan the Lights Off bar code.

Note: This setting does not affect the aimer light. The aiming light can be set using Aimer Mode (page 4-11).

* Lights On

Lights Off

IMAGETEAM™ 2020/4620 System Manual 4 - 9