Hand Held Products 2020, 4620 system manual About the Battery, Charging Information

About the Battery

Use only the Li-ion battery packs provided by Hand Held Products. The

!use of any battery pack not sold by Hand Held Products will void your warranty and may result in damage to your unit.

Power is supplied to the cordless imager by a rechargeable battery that is integrated in the imager handle. Each imager is shipped with a battery. (See Product Specifications beginning on page 13-1.)

Charging Information

The battery is designed to charge while the imager is positioned in the cordless base unit. Refer to "IT2020-5B LED Sequences and Meaning" on page 3-4 for an interpretation of the Charge Status indicators.

•Place the imager in the base that is connected to an appropriate power supply.

Battery Recommendations

•Batteries are shipped approximately 30% to 60% charged and should be fully charged for maximum charge capacity.

•The battery is a lithium ion cell and can be used without a full charge, as well as can be charged without fully discharging, without impacting the battery life. There is no need to perform any charge/discharge conditioning on this cell type battery.

•Do not disassemble the battery. There are no user-serviceable parts in the battery.

•Keep the base connected to power when the host is not in use.

•Replace a defective battery immediately since it could damage the IT4620.

•Don’t short-circuit a battery or throw it into a fire. It can explode and cause severe personal injury.

•Although your battery can be recharged many times, it will eventually be depleted. Replace it after the battery is unable to hold an adequate charge.

•If you are not sure if the battery or charger is working properly, send it to Hand Held Products or an authorized Hand Held Products service center for inspection.

IMAGETEAM™ 2020/4620 System Manual 1 - 3