Hand Held Products 2020, 4620 Standard Product Default Settings Current Application Group

Resetting the Standard Product Default Settings: Current Application Work Group

If you aren’t sure what programming options are in your imager, or you’ve changed some options and want the standard product default settings restored, scan the Standard Product Default Settings: Current Application Group bar code below.

The Menu Commands starting on page 12-6list the factory default settings for each of the commands (indicated by an asterisk (*) on the programming pages).

Note: Scanning this bar code also causes both the imager and the base to perform a reset and become unlinked. Refer to "Imager Modes" on page 3-5 for additional information.

Standard Product Default Settings:

Current Application Group

Resetting the Standard Product Default Settings: All Application Work Groups

The following bar code defaults all of the work groups to the factory settings.

Standard Product Default Settings:

All Application Groups

The Menu Commands starting on page 12-6list the standard product default settings for each of the commands (indicated by an asterisk (*) on the programming pages).

IMAGETEAM™ 2020/4620 System Manual 2 - 7