Chapter 3: Installation
3.4.2 Control by RS-232 serial
Where the external control is via 
is set to 
or 
to enable
3.4.2.1 Serial port parameter settings
Ensure that the chosen serial port is configured to the following:
• | Baud rate: | To match setting of option in the Configuration menu |
• | Data bits: | 8 |
• | Stop bit: | 1 |
• | Parity: | None |
3.4.2.2 Serial port channel selection codes
|
| ASCII |
|
|
|
| Character | Hex | Decimal |
• | Channel 1: | ‘1’ | 0x31 | 49 |
• | Channel 2: | ‘2’ | 0x32 | 50 |
• | Channel 3: | ‘3’ | 0x33 | 51 |
• | Channel 4: | ‘4’ | 0x34 | 52 |
Note: As each channel is chosen using the above
3.4.2.3 Control by channel select input lines
Where the external control is via the four channel select input lines of the OPTIONS port (see pin out), ensure that the configura- tion menu option 
is set to 
to enable the input lines.
The four input lines are suitable for connection to dry contacts or open collector style outputs. Connecting an input line to GND will cause the Wizard DP USB unit to switch all of its functions to the selected channel:
•Channel 1: Channel select input 1 low
•Channel 2: Channel select input 2 low
•Channel 3: Channel select input 3 low
•Channel 4: Channel select input 4 low
If the input line is held low then all other switching requests by other means will be ignored until the line returns to a high (open) state.
If more than one logic input is low (closed) then the lower channel number takes priority.
Note: The input lines have only limited protection against over voltage.
Page 17 |
