S T E P
4
Be careful to assemble all components in the sequence they are presented.
A.Slide main post (T) into main post receiver of mainframe (B). Lock in place with adjustment pin (13).
Note: this leg developer main post is adjustable to properly align the pivot point with your knee joint and accommodate all size users.
B.Align pivot arm (R) with receiver of main post (T). Install pivot shaft (S) to connect the pivot arm and main post. Secure as shown by using:
two 28 (round allen head 10mm x 20mm full thread bolt) * two 35 (spring lock washer 10mm)
two 34 (flat washer 10mm x 30mm)
*Note: You should wrench tighten these bolts now. You will need two 6mm allen wrenches for this step. To lock pivot shaft in place, use both allen wrenches at the same time and turn them in opposite directions to tighten.
C.Install Olympic adapter sleeve (8) as shown using: one 34 (flat washer x 30mm10mm)
one 35 (spring lock washer 10mm)
one 28 (round allen head 10mm x 20mm full thread bolt) Wrench tighten this bolt now. one 2 (plastic
one 12 (rubber donut)
D.See Note 1. Install all three roller pad bars (10) as shown. Install all six foam rollers (9) as shown. Secure each foam roller in place using round plastic end caps (6).
At this point you should wrench tighten all bolts on the bench and the leg developer. Do Not wrench tighten any pad bolts.
Congratulations! You are done. After assembly, you should check all functions to ensure correct operation. If you experience problems, first recheck the assembly instructions to locate any possible errors made during assembly. If you are unable to correct the problem, call the dealer from whom you purchased the machine or call
Note: If any bolts seem to loosen periodically, use Loctite 242 for a
mm
Inch
9
