S T E P
1
Be careful to assemble all components in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until end of step 3.
A.Attach Frame Leveler (10) to Main Base Frame (A) as shown.
Insert two Weight Stack Shims (11) to Main Base Frame (A) as shown.
Insert Convex End Cap (28) to the opening in Main Base Frame (A) as shown.
B.Attach Main Base Frame (A) to Rear Base Frame (B) and Rear Vertical Frame (C) using:
Two 40 (1/2” x 3 1/4” hex head bolt) Four 73 (1/2” washer)
Two 70 (1/2” nylon lock nut) Also use:
Two 55 (3/8” x 2 3/4” hex head bolt) Two 74 (3/8” washer)
Two 71 (3/8” nylon lock nut)
C.Insert two Foot Caps (6) to the ends of Rear Base Frame (B).
Insert Convex End Cap (2) to the top of Rear Vertical Frame (C) as shown.
mm
Inch
10
