S T E P
14
Be careful to assemble all components in the sequence they are presented.
Pec Dec Cable (88)
Stamped Eye End | Stamped Eye End |
2055 mm | 6’ 9” |
|
|
NOTE:
Leave all pulley bolts hand tight until step 15
A.Bolt Pec Dec Cable (88) to Left Pec Dec Cam (P) as shown in diagram 1 using:
One 50 (3/8” x 1” hex head bolt) One 71 (3/8” nylon lock nut)
B.See diagram 1. Route Cable (88) through Pulley Swivel (AC) on the left side, hold cable in place with Pulley (C1) using:
One 51 (3/8” x 1 3/4” hex head bolt) Two 74 (3/8” washer)
One 71 (3/8” nylon lock nut)
C.See diagram 1. Route Cable (88) up and into 90 Degree Double Pulley Holder (CC) and install Pulley (C2) using:
One 51 (3/8” x 1 3/4” hex head bolt) Two 74 (3/8” washer)
One 71 (3/8” nylon lock nut)
B.Insert Cable (88) through Pulley Swivel (AC) on the right side, hold cable in place by installing Pulley (C3) as shown in diagram 2 using:
One 51 (3/8” x 1 3/4” hex head bolt) Two 74 (3/8” washer)
One 71 (3/8” nylon lock nut)
C.Attach Cable (88) to Right Pec Dec Cam (S) as shown in diagram 1 using:
One 50 (3/8” x 1” hex head bolt) One 71 (3/8” nylon lock nut)
mm
Inch
36
