Bosch Appliances manual D623 Series/D625 Series Users Guide Add a Passcode Cmd

D623 Series/D625 Series User's Guide Add a Passcode (Cmd 56)

4.Press [2] to change passcode authority levels. The keypad display scrolls:

To change level for code 3,

Press 3*.

To change level for code 4,

Press 4*.

Push Cmd to exit

5.Enter the passcode number (1 to 32) that you want to change the authority level for, followed by [*] (for example, press [3] [*] to change the authority level for Passcode 3). The keypad display scrolls the following:

Code 3 level 2

Enter new level.

Level choices are 1 to 4.

Push Cmd to exit

If the user does not exist in the system, the keypad emits an error tone.

6.Enter the new authority level (1 to 4) for the passcode that you want to change. The authority levels are determined by the installing company.

7.Press [CMD] to exit this feature. Press [CMD] again to return to the normal display.

Add a Passcode (Cmd 56)

￿I can perform this command.

￿I cannot perform this command.

Use this command to add new passcodes to the system. This command requires the appropriate authority level to add passcodes. To add a new passcode to the system, you must assign an area(s) to the new user in addition to using the other Cmd 56 features (changing a passcode and changing a passcode authority level) as outlined below. Only use this feature under the direction of your security company.

1.Ensure that the system is turned off (On indicator is off).

2.Press [CMD] [5] [6]. The keypad may prompt you to enter a valid passcode.

3.Enter your passcode. The keypad scrolls through the following selections:

Push 1 to change codes.

Push 2 to change authority level.

Push 3 to change areas assigned.

4.Press [3] to assign an area(s) to the new user.

5.Enter the user number you wish to assign area(s) to followed by the [*] key. For example, for User 4, press [4] [*]). The keypad toggles between the following displays:

Code 4 Areas:

----

Press 1 to 4 to toggle areas.

6.Enter the area(s) you want to assign to the new user by pressing the appropriate numeric key(s). For example, if the user is to be assigned to Areas 1 and 2, press the [1] and [2] keys. The keypad displays:

Code 4 Areas: 12--

To remove a currently assigned area(s), press the corresponding numeric key(s). For example, if User 4 is assigned to Areas 1 and 2, but should only be assigned to Area 1, press [2] to remove Area 2 from User 4’s area assignment.

7.Press [CMD] twice to return to the three Cmd 56 selections. Then, press [1] to create a passcode for the new user.

8.Enter the user number followed by [*]. For example, press [4] [*] to create the passcode for User 4.

18 Bosch Security Systems 9/04 46841E