![](/images/new-backgrounds/1009420/942039x1.webp)
D623 Series/D625 Series User's Guide Renew
Renew One-time Passcodes (Cmd 53)
I can perform this command.
I cannot perform this command.
1.Make sure the system is turned off (On indicator is off).
2.Press [CMD] [5] [6]. The keypad may prompt you to enter your passcode.
3.Enter your passcode if necessary. The keypad scrolls through the available
To renew all
Press 0*.
To renew code 5
Press 5*.
4.Press [0] [*] if you want to renew all
5.If you press [0] to renew all
All
6.If you select a single passcode to renew, like Passcode 5, the keypad displays:
7.The system returns to the normal display.
Check System Troubles (Cmd 4)
Your system emits a trouble tone and displays the System Trouble message to alert you to a system trouble event, like low batteries. Use this command to learn what is causing the trouble and the steps to take to correct it.
1.The system may be on or off when a system trouble occurs. If the system is on, you must turn it off to check the trouble. The keypad displays:
Trouble! Press
Cmd 4 to view.
2.Press [CMD] [4]. The trouble tone silences and the keypad scrolls through the list of troubles. Follow the keypad display instructions to view the trouble events.
Point Trouble!
Press 8 to view.
Alarm Memory!
Press 0 to view.
Date/time lost!
Press 5 to set.
System Trouble!
Press 2 to view.
To Test System, press 1.
To Walk Test, press 4.
To reset,
Press 7.
System OK!
Press Cmd.
3.Press [CMD] to return the keypad to the normal display.
The trouble tone continues until the situation is acknowledged.
The trouble tone for AC Failure events sounds at all keypads in all areas. However, the trouble tone must be silenced in each area (silencing it in one area does not silence it in the other areas).
20 | Bosch Security Systems 9/04 46841E |