![](/images/new-backgrounds/1009420/942017x1.webp)
D623 Series/D625 Series User's Guide Check System Status
Check System Status
When the system is Off, press [CMD] to show the current system status. The following message may appear:
Table 4: System Status Messages
|
|
System Status | Description |
Message |
|
System OK | Indicates there are no system |
| troubles. |
System Trouble! | Indicates there is a system trouble. |
Press [4] to view | Refer to Check System Troubles |
| (Cmd 4) on page 20 to determine |
| the nature of the trouble. |
|
|
Points faulted | Indicates the system has faulted |
Press [0] to view | points. Refer to View Faulted |
| Points on page 15 for more |
| information. |
|
|
Log Out of the System
The system remembers passcodes entered for approximately 10 sec. after you stop pressing keys. To log out of the system, press the [CMD] key twice. Logged Out appears on the keypad display.
Silence Alarms
When an alarm occurs, the alarm tone sounds and the display shows the point(s) in alarm. If you enter your passcode before the system dials your security company, the alarm report is aborted.
1.The keypad displays the point(s) in alarm.
Alarm Pt4
Living Room
Enter code to silence alarm
2.Enter your passcode to silence the alarm and turn the system off (if it was turned on). An alarm report is sent to your security company if the alarm is not acknowledged in time.
The display continues to show the point (or points) that caused the alarm.
Silenced alarms listed below
Alarm Pt8
Motion Detector
To remove silenced alarms
from display, hold Cmd
3.Press and hold [CMD] to remove the alarm messages from the keypad display. Refer to Section View Alarm Memory (Cmd 40) on page 21 to see which points caused the alarm.
Bosch Security Systems 9/04 46841E | 9 |