Bosch Appliances D625, D623 manual Remote Arming with Telephone, Area, View Log Cmd

D623 Series/D625 Series User's Guide Remote Arming with Telephone, Area 1

Remote Arming with Telephone, Area 1

￿I can perform this command.

￿I cannot perform this command.

This function controls the built-in telephone arming feature for Area 1. When enabled, the control panel answers the phone on the programmed ring count.

When the control panel answers the phone, it

•Sounds three beeps and starts the handshake tone for remote programming if the control panel is All or Part On.

•Sounds one short beep, waits approximately 3 sec., and then sounds one long beep if the control panel is Off. Press and hold the [5] key* for 2 sec. immediately after the first short arming beep and before the long beep begins.

•Arms if it detects a [5] key press from the telephone (All On with Delay, faulted points are force-armed). The control panel sounds three beeps (new armed state) and then hangs up.

*If arming from a cell phone, quickly press the [5] key three times. If pressing and holding the [5] key for 2 sec. from a house (land line) phone does not produce a tone long enough to arm Area 1, retry by quickly pressing the [5] key three times.

Remotely disarming the control panel cannot be done with a telephone.

View Log (Cmd 85)

￿I can perform this command.

￿I cannot perform this command.

Use this command to display system events, such as alarm events, turning the system All On, Part On, and Part 2 On, and turning the system off. Events are displayed in reverse chronological order.

1.Press [CMD] [8] [5]. The keypad may prompt you to enter a valid passcode.

2.Enter your passcode if necessary. The keypad displays the event and user information and the date and time of the event.

3.Press [*] to view to the next event.

4.Press [CMD] to exit this function and return to the normal display.

Figure 6 shows a sample log event entry as displayed on the Text keypad:

Figure 6: Display layout

		1					1
		Sensor Mon Rstl				Sensor Mon Rstl
	A1 Pt3		SL			08:29	06/13/01
	2			4				6
						5
			3
1 -		Event			4 -	Destination 2
2 -		Event specific			5 -	Time of event
		information			6 -	Date of event
3 -		Destination 1

The first line of the log shows the event description. The second line of the log display alternates between the time and date of the event and the area, point (device), user and communication information for the event. The keypad displays time in a 24-hour format and the date in a MM/DD/YY format.

The log displays the following characters to communicate certain information:

Bosch Security Systems 9/04 46841E 31