OR CancelDrain i

I

Figure 34/llus. 34

".... _.... _wo''tl ........' _

o o o o

Figure 35Illus. 35

38Special Features I Caracteristiques

English

(Special Features, continued)

Cycle Completion Signal

This feature is a tone that sounds when when your Bosch dishwasher finishes washing and drying your dishes, and is available ONLY on Top Control models. You can either disable the tone, or you can set it at one of three volumes (dishwashers with this feature leave our factory with the tone set on the middle volume).

Changing the Cycle Completion Signal Volume

1.Open the dishwasher door far enough to expose the control buttons.

2.Press and hold down the right-most of the two buttons labelled "Cancel Drain", as shown in Figure 34, then press and hotd the On/Off button. When the light on the "Cancel Drain" button you are pressing illuminates,

and the tone begins to sound, release both buttons.

3.Press the "Cancel Drain" button you previously pressed until the tone is at the desired volume, or until it is silent. If your dishwasher has an LED display it wilt also show a "1", "2", or "3" for the volume levels and a 0 when the tone is disabled.

4.Press the On/Off Button.

5.Close the dishwasher door. The Cycle Completion Signal is now set, and you may wash your dishes as usual.

Additional Drying Heat

With this special feature you can raise the temperature of the rinse water, which will result in better condensation drying.

Front Control

1.Press and hold the left-most of the two buttons labelled "Cancel Drain", as shown in Figure 35, then press and hold the On/Off button. When the LED display shows a "0" or a "1", release both buttons. The light above

the left-most "Cancel Drain" button will begin to flash.

2.Press the left-most "Cancel Drain" button until the LED display shows a "1", indicating

thattheAdditionatDryingHeatisenabled.

3.If you wish to disable the Additional Drying Heat, press the left-most "Cancel Drain" button again. The LED display wilt show a "0", indicating that the Additional Drying Heat is disabled.

4.Press the On/Off button. The light above the left-most "Cancel Drain" button wilt stop flashing. You may now wash dishes as usual.

(Continued on Next Page)

Speciales I Caractisticas Especiales

Page 39
Image 39
Bosch Appliances SHX33AI manual Changing the Cycle Completion Signal Volume, Additional Drying Heat