Bosch Power Tools 4405 manual Crown Molding Laying Flat on Table

Saw Operations

Crown Molding Laying Flat on Table

Follow these instructions for cutting crown molding:

1.Set the bevel and miter angles using Chart 1 below. Tighten the miter lock knob and the bevel lock handle (Figure 33).

2.Position molding on saw table. Use the chart below for correct position. Clamp workpiece in place using the quick clamp.

NOTE: ALWAYS TAKE A TEST CUT USING SCRAP TO CONFIRM CORRECT ANGLES.

! WARNING	Use clamping position that does not
	interfere with operation. Before

switching on, lower head assembly to make sure clamp clears guard and head assembly.

3.Follow procedures for either chop cut or slide cut (see page 24).

4.Wait until blade comes to a complete stop before returning head assembly to the raised position and/or removing workpiece.

	Workpiece
	Clamp
33.9º
Bevel	Crown
	Molding

31.6º Miter

Figure 33. Crown Molding Laying Flat

CROWN MOLDING CUTS - CUTTING METHOD #1 - FLAT ON TABLE

MAX. SIZE: 10-1/4"

F
E		38º
N
C		W
E
		A
	TABLE	L
		L

52º CEILING

C D

A B

ANGLES OF U.S.	INSIDE	OUTSIDE
STANDARD MOLDING	CORNER	CORNER

TYPE	MITER	BEVEL	TYPE	MITER	BEVEL
OF	(TABLE)	(TILT)	OF	(TABLE)	(TILT)
CUT	SETTNING	SETTING	CUT	SETTNING	SETTING

INSIDE CORNER			OUTSIDE CORNER
	RIGHT			RIGHT
LEFT SIDE A	31.6º	33.9º	LEFT SIDE C	31.6º		33.9º
PLACE TOP EDGE OF			PLACE BOTTOM EDGE OF
MOLDING AGAINST FENCE - SAVE LEFT END OF CUT			MOLDING AGAINST FENCE - SAVE RIGHT END OF CUT
	LEFT			LEFT
RIGHT SIDE B	31.6º	33.9º	RIGHT SIDE D	31.6º	33.9º
PLACE BOTTOM EDGE OF			PLACE TOP EDGE OF
MOLDING AGAINST FENCE - SAVE LEFT END OF CUT			MOLDING AGAINST FENCE - SAVE RIGHT END OF CUT

29.