Bosch Power Tools 4405 manual Detent Override, Base Extensions

Basic Saw Operations

Detent Override

To Engage:

1. Lift the miter detent trigger.

Clip Edge

Detent

2.	Push the detent override clip forward and latch
	in place over edge. Release miter detent trigger
	(Figure 23).
3.	Move miter arm to any position on the miter
	scale.
4.	Lock the miter lock knob to retain miter position.

To Disengage:

Override Clip

5.Loosen miter lock knob and lift the miter detent trigger to release the detent override clip. The clip should automatically disengage and the table should lock into any desired miter detent.

Table

Miter Detent

Trigger Miter Lock

Knob

Figure 23. Detent Override

Base Extensions

! WARNING	So as to provide sufficient (mini-
	mum 6”) spacing from hand to

saw blade, extend the sliding fences and base extensions when making extreme bevel, miter or compound cuts.

The base extensions can also be used to provide extra support for long workpieces.

Adjusting the Extensions:

1.Loosen the base extension clamping levers.

2.Extend sliding base extensions to the desired position.

3.Press the levers down to clamp the extensions into place.

If the clamping force of the Base Extension Clamping Levers needs to be adjusted, simply pull the red tab outward and rotate it toward the center of the saw. Let the red tab spring back into a new groove. When the red tabs are rotated down to clamp the rods, they will grip the rods with greater force.

Base

Extension

Base Extension

Clamping lever

Figure 24: Base Extensions

22.