Adjustments
Blade 33.9° To Table
33.9° Blade Alignment Check
NOTE: You must check and align 45º and 90º set- tings first before doing 33.9º (See pages 13 and 14).
1. Rotate table to 0° position and lock in place.
2. Make sure head assembly is pushed back fully against stop and slide rail lock knob is tightened.
3. Lower head assembly. Lock in place.
4. Make sure the 33.9º bevel stop screw jam nut is in the active position,
5. Loosen bevel lock handle and tilt the head |
|
assembly to 33.9° bevel. Check the 33.9° |
|
bevel stop. The bevel indicator should be on |
|
the 33.9° mark. | Figure 11. Blade 33.9° To The Table |
6.If the blade is not 33.9° with the table, adjust 33.9°bevel stop.
33.9° Blade Alignment Adjustment
1.Lower the 33.9° bevel stop screw jam nut using 12mm or adjustable wrench (Figure 12).
2.Loosen bevel lock handle.
3.Lower the saw onto the 33.9º stop.
4.Adjust the 33.9º bevel stop until bevel indica- tor is pointing to the 33.9° mark on the bevel scale (see Figure 12). Tighten 33.9° jam nut.
45º/33.9º
Stop 
33.9º Stop 
Screw
Jam Nut
Figure 12. Bevel 33.9° Stop Screw and Jam Nut
15.
