18.
Installation
Portable Mounting Using Clamps•If using bolts or screws is not possible, clamp the
slide compound miter saw to a workbench or
table top using clamps.
•Place a “C” clamp on each of the clamping areas
and secure (Figure 17).
Note: Use of clamps will limit use of extreme
miter angles.
Figure 17. Portable Mounting Using Clamps
Clamping Area
Stability Bar Adjustment For added support of the table during cutting, the
stability bar should be adjusted before use.
1. Loosen the knob for the stability bar.
2. Slide the stability bar up or down until it con-
tacts the workbench.
Note: If the workbench surface is not flat, the
stability bar may require readjustment at different
miter angles.
3. Tighten the knob.
Stability Bar
Adjustment Knob
Stability Bar
Workbench
Clamping Area