Router Table Assembly
ASSEMBLING THE ROUTER TABLE
TOOLS REQUIRED
•#1 and #2 Phillips screwdrivers (not included)
•3/8″ wrench or nutdriver (not included)
• 4mm hex key (included) | FIG. 1 |
| |
6 | 5 | ||
|
HINT: Applying bar soap or bees wax to the screw threads (35 and 38) will make them easier to install into the panels.
ASSEMBLE SIDES TO BACK (Fig. 1)
NOTE: The mounting holes for the left and right panels |
|
|
are spaced so that the panel will only fit on the correct |
|
|
end of the back. Before attaching the panels, make |
|
|
sure that the predrilled holes for the hinges and door | 4 | 38 |
catch are on the INSIDE surface of the panel. |
|
|
1.Holding the back panel (6) upright, with the cord cutout on the left (see Fig. 1), attach the left side panel (4) to the back panel using two
2.Attach the right side panel (5) to the back panel using two
3.Tighten all fasteners securely with the 4mm hex key (43). The screw head will stand slightly above the panel surface. DO NOT OVERTIGHTEN!
ATTACHING THE BASE (Fig. 2) | FIG. 2 | 38 | |
1. Turn the sides/back assembly upside down, and | 7 | ||
| |||
|
| ||
position the base (7), with countersunk holes on |
|
| |
the base facing out, on the sides/back. |
|
|
2.Align the holes in the base with the holes in the sides and back, and attach using five
3. Tighten all fasteners securely with the 4mm hex key (43). The screw head should be in the counterbore, below the panel surface. DO NOT OVERTIGHTEN!
10
