Router Table Assembly

ALWAYS MAKE SURE THAT THE ROUTER IS TURNED OFF AND THE POWER CORD IS UNPLUGGED BEFORE MAKING

ANY ADJUSTMENTS.

TABLETOP INSERTS (Fig. 16)

This router table includes three tabletop inserts with the following hole sizes:

1in diameter (9), for use with bits with diameters up to 7/8

2in diameter (10), for use with bits with diameters up to 178

234in diameter (11), for use with bits with diameters up to 258

No insert is used for bits with diameters over 258and up to 312.

Do NOT use the router table with bits over 312in diameter!

TO INSTALL TABLETOP INSERTS (Fig. 16):

1.Select the tabletop insert that best accommodates the router bit to be used.

2.Press the insert into the large hole in the router mounting plate (Fig. 16). If the fence is in the way, loosen the clamping knobs on the fence and slide the fence back out of the way.

3.Press down evenly over the tabs until the insert locks into place.

4.To remove, pull up gently until the tabs disengage. When not in use, store tabletop inserts in a resealable plastic bag in the router table cabinet.

DO NOT attempt to remove tabletop inserts from the tabletop unless the router is unplugged.

FIG. 16

 

1HOLE (9)

358HOLE

2HOLE (10)

IN ROUTER

MOUNTING

 

PLATE

234HOLE (11)

 

18

Page 18
Image 18
Bosch Power Tools RA1171 manual To Install Tabletop Inserts Fig