Bosch Power Tools RA1171 manual Attach Router to Mounting Plate Figs

Router Table Assembly

CHART 1

Router	Router	Hole	Fasteners	Mount
Brand	Model	Pattern	Required	Type
Bosch	1613 series	A	1/4-20 x 11⁄2″ Phillips machine screws (45),	2
			large washers (31), and 1/4-20 nuts (48)
Bosch	1617 series	B	10-24 x 3/4″ Phillips machine screws (46)	1
	(fixed base
	models only)
Bosch	1619EVS	C	1/4-20 x 11⁄2″ Phillips machine screws (45),	2
			large washers (31), and 1/4-20 nuts (48)
DeWalt	DW616, DW618	B	#8-32 x 3/4″ Phillips machine screws (47)	1
	(fixed base only)
Hitachi	M12VC	B	#10-32 x 3/4″ Phillips machine screws (44)	1
Makita	RF1100, RF1101	B	#10-24 x 3/4″ Phillips machine screws (46)	1
Milwaukee	5615, 5616	B	#10-24 x 3/4″ Phillips machine screws (46)	1
Porter Cable	690 series,	B	#10-24 x 3/4″ Phillips machine screws (46)	1
	7529 plunge router,
	and 892–895 series
	(fixed base only)

ATTACH ROUTER TO MOUNTING PLATE (Figs. 11 and 12)

1.Remove the plastic subbase from your router (Fig. 11).

2.If your router has its own dust extraction hood that mounts to the top of the metal router base and you want to use it under the router table, this is a convenient time to install it.

3.Using Chart 1, determine the hardware and mount type for your router.

•For most router models, the screws are driven into threaded holes in the router’s base (mount type 1).

•For some router models, the screws go all the way through the base and are fastened with washers and nuts (mount type 2).

The top and front of the mounting plate is determined by the location of the guide pin holes. These holes are to the right of the bit opening.

4.Refer to the mounting plate guide (Fig. 10) on page 14 and align the appropriate mounting plate holes for your router to the router base holes. Make sure that the depth adjustment controls on the router face the front of the mounting plate.

5.Mount your router to the mounting plate (Fig. 12).

FIG. 11

FIG. 12

REMOVE SUBBASE

15