Bowflex ElitePlus manual Attach the Seat Rail to the Main Assembly

Assembly Guide
Step 9 - Attach the Seat Rail to the Main Assembly	Figure 9
Locate the following items:
• From Step 4 - Main Assembly	Main
	Assembly
• From Step 8 - Seat Rail Assembly
• Item #12 - Seat Rail Knob
• Item #J - (1) 3/8" X 4 1/4" Button Head Screw
• Item #N - (2) 3/8" Washers
• Item #O - (1) 3/8" Nylock Nut	Seat Rail
• Item #Q - (1) Bolt Cover	Bracket
	12
Align the holes on the Seat Rail Assembly (from Step 8)	J
with the holes in the Rail Bracket on the Main Assembly	Rail
(from Step 4), as shown in Figure 9.	Assembly
Insert the Seat Rail Assembly into the Seat Rail Bracket,	O
and then place (1) 3/8" Washer (Item #N) over the end of
	N
(1) 3/8" X 4 1/4" Button Head Screw (Item #J). Insert the
screw through the aligned holes, as shown, and place (1)
3/8" Washer and (1) 3/8" Nylock Nut (Item #O) over the
end of the screw to secure.
Do not over-tighten the hardware from Step 9.

Note:Tighten the nylock nut enough that the threads of the screw extend through the nylock nut, but loosely enough that the Seat Rail Assembly can move freely.

At this time, place (1) Bolt Cover (Item #Q) over the

Nylock Nut installed during Step 9. Then, thread the Seat

Rail Knob (Item #12) into the top hole on the Seat Rail

Bracket, as shown in Figure 9, but do not over-tighten.

A-8