Assembly Guide

 

 

Step 10 - Attach the Leg Extension Pivot Tube

Figure 10a

G

Bracket

 

 

 

Locate the following items:

N

 

 

 

 

 

Item #13 - Leg Extension Pivot Tube

 

 

O

 

 

 

• From Step 9 - Main Assembly

 

 

 

Item #30 - Lock Out Pin

 

 

 

Item #G - (1) 3/8" X 2 3/4" Button Head Screw

“Curve”

 

 

 

 

 

Item #N - (2) 3/8" Washers

 

 

 

Item #O - (1) 3/8" Nylock Nut

 

 

 

Item #Q - (1) Bolt Cover

 

 

 

 

13

 

 

Undo the twist ties from the Pivot Bushings. Align the holes

 

 

 

located on the“curve” of the Leg Extension PivotTube (Item #13)

 

 

 

with the holes on the bracket of the Rear Leg, as shown in Figure

 

 

Rear Leg

 

 

 

10a.

 

 

 

Place (1) 3/8" Washer (Item #N) over the end of (1) 3/8"

 

 

 

X 2 3/4" Button Head Screw (Item #G). Thread the

 

 

 

screw through the aligned holes and bushings and secure

 

 

 

by placing (1) 3/8" Washer and (1) 3/8" Nylock Nut (Item

 

 

 

#O) over the end of the screw, as shown in Figure 10a.

 

 

 

Do not over-tighten hardware from Step 10.

Figure 10b

 

 

 

 

 

Place (1) Bolt Cover (Item #Q) over the Nylock Nut installed during Step 10.

Holes

Note: When storing the Rail Assembly, insert the Lock Out Pin (Item #30) through the holes in the Pivot Tube to temporarily hold the Leg Extension in place while folding the Rail up (see Figure 10b).

30

Leg Extension

A-9

Page 11
Image 11
Bowflex ElitePlus manual Attach the Leg Extension Pivot Tube, 10a