Assembly Guide

Step 16 - Attach the Upper Lat Tower to the Lower

Locate the following items:

From Step 15 - Upper Lat Tower Assembly

From Step 14 - Main Assembly

Item #E - (6) 3/8" X 3/4" Button Head Screw

Item #N - (6) 3/8" Washers

Carefully insert the end of the Upper Lat Tower into the open end of the Lower Lat Tower. Align the holes on the Upper Lat Tower with the holes on the Lower Lat Tower.

Place (6) 3/8" Washers (Item #N) over the ends of (6) 3/8" X 3/4" Button Head Screws (Item #E) - one washer per screw. Thread the screws into the aligned holes, as shown in Figure 16.

Completely tighten hardware installed during Step 16.

Figure 16

Upper Lat

Tower

N

E

Lower Lat

Tower

Step 17 - Attach the Rod Box with Power Rods® to the Rod Box Frame

Locate the following items:

Item #24 - Rod Box Frame

Item #25 - Rod Box with Power Rods®

Item #B - (3) #10 X 1" Phillips Head Screws

Item #L - (3) 1/4" Washers

Place the Rod Box Frame (Item #24) and Rod Box with Power Rods® (Item #25) onto one side as shown in Figure 17. Slide the Rod Box with Power Rods® into the Rod Box Frame until the Rod Box is completely seated in the Rod Box Frame.

Place (3) 1/4" Washers (Item #L) over the ends of (3) #10 X 1" Phillips Head Screws (Item #B) - one washer per screw. Insert the screws through the slot on the Rod Box Frame and thread into the holes in the Rod Box with Power Rods®.

Completely tighten hardware installed during Step 17.

Figure 17

24

L

B

Slot

25

A-13

Page 15
Image 15
Bowflex ElitePlus manual Attach the Upper Lat Tower to the Lower, Attach the Rod Box with Power Rods to the Rod Box Frame