Assembly Guide

Step 11 - Attach the Rollers to the Leg Extension Locate the following items:

From Step 10 - Main Assembly

Item #14 - Foam Rollers

Item #15 - Foam Roller End Caps

Item #16 - Short Chrome Roller Tubes

Item #17 - Long Chrome Roller Tube

Item #18 - Roller Tube Spacers

There are (3) Chrome Roller Tubes on the Leg Extension. Place the Long Chrome Roller Tube (Item #17) through the hole closest to the Seat.

There are two holes possible in the Leg Extension Pivot Tube for the lower of the Short Chrome Roller Tubes (Item #16). Select the correct lower hole for your height - the Roller should rest on your lower shin above the ankle. Insert the (3) Chrome Roller Tubes through the holes on the Leg Extension Pivot Tube and Rear Leg, as shown in Figure 11.

Slide (2) Roller Tube Spacers (Item #18) over each end of the Long Chrome Roller Tube. Then, slide (2) Foam Rollers (Item #14) over the ends of all three tubes. Cap the Roller Tubes with the (6) Foam Roller End Caps (Item #15).

Note: Use a Rubber Mallet to secure the End Caps.

Step 12 - Attach Leg Cable to the Leg Extension Locate the following items:

From Step 11 - Main Assembly

Item #AA - (1) Leg Cable

Item #F - (1) 3/8" X 2 1/2" Button Head Screw

Item #N - (2) 3/8" Washers

Item #O - (1) 3/8" Nylock Nut

Item #Q - (1) Bolt Cover

Slide the hooked end of the Leg Cable beneath the Leg Extension Pulley and into the hole on the Leg Extension Pivot Tube, as shown in Figure 12.

Place (1) 3/8" Washer (Item #N) over the end of (1) 3/8" X 2 1/2" Button Head Screw (Item #F). Thread the screw through holes in the Leg Extension and cable end. Place (1) 3/8" Washer and (1) 3/8" Nylock Nut (Item #O) over the end of the screw, as shown in Figure 12, and tighten.

Completely tighten hardware installed during Step 12.

Place (1) Bolt Cover (Item #Q) over the Nylock Nut installed during Step 12.

Figure 11

18 15

14

16

Figure 12

F

N

O

17

AA

Page 12
Image 12
Bowflex ElitePlus manual Completely tighten hardware installed during Step