Assembly Guide

Step 22 - Attach the Bench to the Seat Assembly

Locate the following items:

Item #29 - Bench Pad

From Step 6 - Seat Assembly

The Bench easily attaches and releases from the Seat. To attach the Bench, insert the half hinge on the end of the Bench into the half hinge on the seat. To remove the Bench, lift up on the long portion and pull away from Seat.

Figure 22

29

Note: At this time, carefully go over your entire Bowflex® Elite™ home gym, tightening all screws, nuts and other hardware securely before exercising on your Bowflex® Elite™ home gym.

Steps 23 through 26 illustrate how to route and connect the Cables to your new Bowflex® Elitehome gym.

Seat Assembly

Step 23 - Route the Rod Cables

Locate the following items:

Item #S - (2) Hand Grips

Item #V - (2) Snap Hooks

Item #Y - (2) Rod Cables with (2) Snap Hooks (attached)

Un-wrap the Cables from both Pulleys on the Chest bar. Pull one end of the Cable from the Chest Pulley upwards. Attach the Cable to one Rod Cap by hooking the Rod Hook through the hole in the Rod Cap.

Then, fasten one Hand Grip to the Snap Hook on the opposite end of the Cable, as shown in Figure 23.

Repeat for remaining Chest Pulley Rod Cable.

Figure 23 - Rod Cables

Rod

Cap

Rod

Hook

Hand

Grip

Snap

Hook

A-16

Page 18
Image 18
Bowflex ElitePlus manual Attach the Bench to the Seat Assembly, Route the Rod Cables