SERVICE PROCEDURE D24-IV
Control Board Replacement
DANGER
120 volt exposure. To avoid personal injury, unplug while performing this procedure.
Control board replacement | Step 2: Unplug wire connections from board. |
Step 1: Disconnect Power | |
23 | 24 |
Depress
plasticWire connections tabs
Step 3: To remove board, tilt control panel to the right and slide control hook tabs from slots in control panel.
25
Slots in control panel
Unhook tabs from control panel slots
To remove lower sensor
Remove clip, pull sensor out.
26
Remove clip
Pull out sensor
IMPORTANT
When replacing lower sensor, make sure sensor is fully inserted into the well and securely held by the clip on the well groove. (see photo 25)
Page 34
34
