Troubleshooting

Step 2: Press the “Set” button to enter the setting mode. “Setpoint” will flash in the water heater display.

°F setpoint

idle

Status Operational

SELECTSET

Step 3: To raise the temperature setpoint, press the “Temperature Up” button until the desired temperature is shown on the water heater display.

NOTICE

The maximum temperature that can be set in the Water Heater Display is limited to the “Max Setpoint” described previously. To change the “Max Setpoint”, refer to the procedure “To Change the Maximum Setpoint Limit…" described previously under “Accessing the Service Mode on the Water Heater Display”.

WARNING Setting the water temperature to the maximum set point can result in scalding hot water delivered to the faucets. It is highly recommended that the maximum setpoint be adjusted to the lowest temperature possible for the needs of the installation. Make sure the water heater control display is not in a public area that can result in the temperature settings being improperly adjusted.

°F

setpoint

%

 

idle

 

 

Status Operational

 

 

SELECT

SET

 

Step 4: To lower the temperature setpoint, press the “Temperature Down” button until the desired temperature is shown on the water heater display.

"Setpoint" Flashes

°F setpoint

idle

Status Operational

SELECTSET

Page 16

16

Page 16
Image 16
Bradford-White Corp D-38T-155 service manual Setpoint Flashes