LIGHTING AND SHUT-DOWN INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
A. This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand.
B. BEFORE OPERATING smell all around the appliance for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electric switch;
do not use any phone in your building.
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the fire department.
C. Turn off main power to the water heater.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
1.STOP! read the safety information above on this label.
2.Set the thermostat to lowest setting.
3.Turn off all electrical power to the appliance.
4.This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand.
5.Turn off the main power switch.
6.Wait (5) minutes to clear out any gas. If you then smell gas, STOP! Follow "B" in the safety information above on this label if you don't smell gas, go to next step.
7.Turn on main power.
8.Set the thermostat to desired setting.
"GREEN LIGHTED" MAIN POWER SWITCH
TEMPERATURE UP
TEMPERATURE DOWN
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting. | 2. Turn off the main power switch. |
|
|
Figure 26.
Lighting Instruction Label
40