Hardware Troubleshooting
Troubleshooting the 10/100 PS
Telnet
Open a telnet session to send a ZPL command from a DOS prompt. This procedure can be used when running Vx.15.x or later firmware. In this example, a ZPL II command is used to cause a label to print.
Note • You do not need to open a telnet session if you pinged the printer using the previous procedure. The purpose of these two procedures is to identify whether your PC can communicate with your printer.
To open a telnet session on your PC, complete these steps:
1.Open a DOS window.
To open a DOS window, click on Start > Run.
2.In the Open text box, type: cmd
3.From the DOS prompt, type:
telnet xxx.xxx.xxx.xxx 9100
where xxx.xxx.xxx.xxx is the IP address of the print server.
This will connect your PC to the 10/100 Internal PS through the parallel port of the printer.
4.Enter ~WC.
This ZPL command will print a configuration label on your printer.
5.Click the X in the upper
If the configuration label prints, the issue is not a communication problem between the printer, the print server, or the PC.
85
07/18/2008 | BradyConnect 10/100 Internal Print Server User Guide | Y885775 |
