TM
SLE100 Installation Manual
1.Install 4 mounting bolts in the wall at the desired location. The template provided in Figure 3-3 can be used to establish the hole pattern on the wall. The bolts (normally ⅜-16) should extend 0.8 to 3.0 inches (2cm to 7.5cm) from the wall and be strong enough to secure the radio to the wall under foreseeable environmental conditions. The environmental conditions may include, but not limited to, wind, rain, ice, etc. Depending on the wall material the mount is being attached to, a different size bolt may be appropriate. In this case, bolts up to ¾ inch in diameter may be used.
1.Secure the ‘Wall-Mounting Bracket’ to the wall using the appropriate sized nuts, lock washers, and flat washers for the bolts used.
2.Attach the Yoke Mounting Bracket to the mount, with Teflon shim in-between, using 2 each of the supplied ⅜-16 x ¾ bolts, ⅜ lock washers, and ⅜ flat washers. Tighten the bolts just enough to allow the yoke to move back and forth without binding.
3/8 Lock Washer
3/8 Flat Washer
Mounting Bracket
Teflon Shim
Radio Yoke
Figure 3-2 Attaching the Yoke to the Mounting Bracket
