Briggs & Stratton PRO4000 01932, PRO6500 01933 Troubleshooting, Problem Cause Correction

BSPP Generator

TROUBLESHOOTING

Problem	Cause		Correction
	1.	One of the circuit breakers is	1.	Reset circuit breaker.
		open.
	2.	Fault in generator.	2.	Contact Authorized service
No AC output is available, but				facility.
	3.	Poor connection or defective	3.	Check and repair.
generator is running.
		cord set.
	4.	Connected device is bad.	4.	Connect another device that is in
				good condition.
	1.	Short circuit in a connected load.	1.	Disconnect shorted electrical
Generator runs good at no-load				load.
	2.	Generator is overloaded.	2.	See "Don't Overload Generator".
but "bogs" down" when loads are
connected.	3.	Shorted generator circuit.	3.	Contact Authorized service
				facility.
Generator will not start; or starts	Low oil level.		Fill crankcase to proper level or place
and runs rough.			generator on level surface.
Generator shuts down during	1.	Out of gasoline.	1.	Fill fuel tank.
	2.	Low oil level.	2.	Fill crankcase to proper level or
operation.
				place generator on level surface.
Generator lacks power.	Load is too high.		See "Don't Overload Generator".

16