11 CEE map configuration

Applying a CEE provisioning map to an interface

To apply a CEE provisioning map, perform the following steps from privileged EXEC mode. 1. Enter global configuration mode.

switch#configure terminal

2. Specify the 10-gigabit Ethernet interface. In this example, 0/2 is used.

switch(config)#interface tengigabitethernet 0/2

3. Apply the CEE map on the interface.

switch(conf-if-te-0/2)#cee default

4. Enter the copy command to save the running-config file to the startup-config file.

switch(config)#do copy running-config startup-config

Verifying the CEE maps

To verify the CEE map, perform the following steps from privileged EXEC mode. 1. Enter global configuration mode.

switch#configure terminal

2. Verify the CEE map provisioning for a specified name.

switch(config)#do show cee maps name

122

Converged Enhanced Ethernet Administrator’s Guide

 

53-1002163-02

Page 144
Image 144
Brocade Communications Systems 53-1002163-02 manual Applying a CEE provisioning map to an interface, Verifying the CEE maps