Brocade Communications Systems 53-1002163-02 manual Interface port-channel

2 CEE Command Line Interface

NOTE

At system startup, if you try to enter privileged EXEC mode before the system has fully booted, the following message is displayed:

%Info: Please wait. System configuration is being loaded.

After the system has fully booted, a RASlog message indicates that the CEE CLI is ready to accept configuration commands.

TABLE 4	CEE CLI command modes
Command	Prompt	How to access the command mode	Description
mode
EXEC	switch>	Enter the cmsh command at the	Display running system information
		Fabric OS prompt after you have	and set terminal line parameters.
		logged in as an appropriate user.

Privileged	switch#	From the EXEC mode, enter the
EXEC		enable command.

Display and change system parameters. Note that this is the administrative mode and also includes EXEC mode commands.

Global	switch(config)#	From the EXEC mode, enter the		Configure features that affect the
configuration		configure terminal EXEC command.		entire switch.
Interface	Port-channel:	From the global configuration mode,		Access and configure individual
configuration	switch(conf-if-po-63)#	specify an interface by entering one		interfaces.
		of the following commands:
	10-Gigabit Ethernet (CEE port):	•	interface port-channel
	switch(conf-if-te-0/1)#	•	interface tengigabitethernet
		•	interface vlan
	VLAN:
	switch(conf-if-vl-1)#
Protocol	LLDP:	From the global configuration mode,		Access and configure protocols.
configuration	switch(conf-lldp)#	specify a protocol by entering one of
		the following commands:
	Spanning-tree:	•	protocol lldp
	switch(conf-mstp)#	• protocol spanning-tree mstp
		•	protocol spanning-tree rstp
	switch(conf-rstp)#
	switch(conf-stp)#	•	protocol spanning-tree stp

16	Converged Enhanced Ethernet Administrator’s Guide
	53-1002163-02