Brother 9500pc manual 14

Lamp display

The condition of the PT-9500PC can be determined by the power button lamp (green) and the ERROR lamp (red).

Lamp condition				use
		Condition	Remedy
Power button	ERROR lamp
		PT-9500PC standby		Before
(green)	(red)
Lit	Not lit	condition	—
Flashing	Not lit	Receiving data	—
		Receiving data	Install the tape cassette and close the
		No tape cassette	tape compartment cover.
Flashing	Lit
		Receiving data	Close the cover.
		Tape compartment cover is
		open.
		During PT-9500PC standby	Install the tape cassette and close the
		No tape cassette	tape compartment cover.
Lit	Lit
		During PT-9500PC standby	Close the cover.
		Tape compartment cover is
		open.
		During printing	Install the correct tape cassette and close
		No tape cassette
			the tape compartment cover.
		Incorrect tape cassette
		During printing	Close the cover.
		Tape compartment cover is
Lit	Flashing	open.
		Empty tape cassette	Install a tape cassette containing tape
			and close the tape compartment cover.
		Transmission error	The PT-9500PC will return to standby
			after 5 seconds.
		Cutter error	Confirm that the tape is not jammed in
			the PT-9500PC. If necessary, turn the
Lit	Flashing fast		PT-9500PC off and on.
			If the ERROR lamp continues to flash,
		Roller holder error	contact the retail outlet where the
			PT-9500PC was purchased or your local
			authorized service center.
			Turn the PT-9500PC off and on.
	Flashing very	EEPROM error	If the ERROR lamp continues to flash,
Lit			contact the retail outlet where the
	fast	Circuit board error
			PT-9500PC was purchased or your local
			authorized service center.

13